Tutorial of DIY beautiful vase

1. Mark it, cut it from the middle of the pot, and leave a height of 7.5 to 8 cm above the edge of the vase you want. After this height, it will be cut into thin strips and folded.

2.Measure it, then cut straight and evenly distributed strips around the pot. Cut the first partition into two, and then continue to cut each one into two, thus cutting out the average thin strips.

3. Carefully press these strips outward to make a circle of flat edges.

4. Turn the pot upside down and put it on a flat surface, so as to ensure that the edges are equal in height.

5. Weave the tips of the strips above one strip on the side and wear them below the next two. Fold it so that the tip of the bar is at the position indicated by the arrow in the figure.

6. The next root is folded in the same way, but this one is woven over the two on the side and goes under the next one.

7. The next root is folded in the same way, but this one is woven over the two on the side and goes under the next one.

8. Weave according to this pattern until the last three, and press them under the side one to finish weaving.